Steeline Corrugated is a very popular, aesthetically pleasing roof and wall material.
Now made from light gauge, high tensile steel, it is strong, light and able to span longer distances.
Manufactured locally, using quality Colorbond® or Zincalume® steel, Steeline Corrugated is strong and long lasting.
As specialists in all things steel, we can assist with your entire project from start to finish. From ideas to advice, installation and everything in between, Steeline offers a full range of services to make projects a breeze.
Not sure where to start? Our trained experts can answer any questions, no matter how big or small. You can call your local Steeline team for advice, or request a free quote anytime.
Manufactured right here in Australia from only the best BlueScope steel, our tried and tested products are guaranteed to last well into the future.
Overlapped sheets of corrugated are to be fixed progressively along the building, in the opposite direction to the prevailing weather. This gives complete weather protection and a fast and efficient method of installing the roof. Each sheet consists of an ‘over rib’ and an ‘under rib’ and when put together they form an anti-capillary drain, preventing water entry.
Lift packs of corrugated onto the roof frame, ensuring all sheets are the right way up, and with the over edge facing the end of the roof where laying is to commence. To prevent roof damage, walk on at least two ribs, and ensure your weight is evenly distributed as you walk across the supports. When the roof pitch is less than 25o or where there are extreme weather conditions, turn the sheet ends up approx. 80° at the high end and down approx. 15° at the gutter or low end. A shifting spanner can be used to do this.
When two or more sheets are required for full length cover, start laying at the gutter and work up to the ridge, then start the next run. The minimum end laps required are:
Roofs – Pitch up to 15° – 230mm
Roofs – Pitch over 15° – 150mm
Walls – 100mm
End laps in roofs with a pitch of <5° (1 in 12) are to be sealed. End laps must be positioned over a support and the support spacing on either side is to be those recommended for an end span.
Steel framing (up to 5mm):
Side Lap Fasteners
Side lap fasteners are to be added at the midspans of the sheets to lend support where spacings are over 900mm for roofs and 1200mm for walls, to ensure weatherproofing. Use No 8×12 hex head type 5 self drilling screw with neo washer or blind rivets.
Roofs – Pierce fix through crests only using 3 fasteners/sheet or 5 fasteners/sheet depending on the location. At the end of sheets 5 fasteners/sheet must be used. Walls – Pierce fix through crests or valleys. 3 fasteners/sheet or 5 fasteners/sheet can be used depending on location. At the ends of sheets 5 fasteners/sheet must be used. If valley fastening is used side lap fasteners must be added beside each main fastener.
When unloading bundles of sheeting with a crane always use a spreader bar and fabric slings to prevent damage. When manually handling sheets use clean dry gloves and do not drag sheets over each other. Storage of sheets should be above ground and under cover. Crest fasteners must not be over-tightened but driven in until slight deformation of the rib is observed and the neoprene washer is fully sealed.
Do not locate fasteners less than 25mm from the end sheets. Do not use punches to form holes for fasteners. Holes are to be drilled or self drilling fasteners are to be used.
Steeline Corrugated has an effective coverage of 762mm when laps of 1.5 ribs are used.
Corrugated is designed so that sheets are to be overlapped by a minimum of 1.5 ribs to ensure the water-proofness. The minimum recommended roof pitch is 5°.
Additional information available at: