Steeline Quad Gutter is a traditional gutter that gives your home that modern look. A choice can be made from a number of sizes available to compliment the project at hand. Each gutter has a smooth and aesthetically pleasing appearance and with the option of the larger sizes to ensure the catchment of more water from the roof area during a heavy storm.
This gutter is available in 115mm, 125mm and 150mm widths to meet catchment requirements.
Made from quality Colorbond® or Zincalume® Steel, Steeline Quad Gutter is strong and long lasting.
*Please note: The exact dimensions of each product may vary slightly between stores so if you need to match your existing profile please check with your local branch before ordering*
As specialists in all things steel, we can assist with your entire project from start to finish. From ideas to advice, installation and everything in between, Steeline offers a full range of services to make projects a breeze.
Not sure where to start? Our trained experts can answer any questions, no matter how big or small. You can call your local Steeline team for advice, or request a free quote anytime.
Manufactured right here in Australia from only the best BlueScope steel, our tried and tested products are guaranteed to last well into the future.
Fixing to timber fascia
Fix a bracket at the high end of fall first, then fix a bracket at the low end of the fall. Stringline a common datum on both brackets and install the remaining brackets at the required spacings (not exceeding 1200mm), with common datum on the stringline.
The brackets are best attached to the fascia with the use of 20mm bugle head self drilling screws.
Attaching gutter to brackets
Hook the front of the gutter onto the end of the long arm of the brackets and slide the back of gutter under the long arm until it is hard up to the back of the bracket. Push the gutter into the upright position, lifting the bottom of the gutter onto the platform provided by the bracket. When the gutter is in the correct position, turn down both tabs of the gutter brackets onto the back of the gutter, completing the attachment.
Spring Clip System
Fixing to metal fascia is made incredibly simple by using the Steeline spring clip. The clip snaps over the metal fascia and has six teeth at alternative heights. The fall of gutter to downpipe outlet is determined by the height of where the gutter is attached to these teeth. The face of gutter is then supported by the Steeline overstraps, which connect to the front bead of gutter and top bead of fascia.
Gutter brackets are to be placed at stop ends and between stop ends at intervals of no more than 1200mm. Where metal fascia is used, brackets must be placed within 150mm either side of the rafter brackets.
Pre-formed stop ends provide a neat finish to straight runs of gutter and require less labour and skill than site formed ends. However both methods of end stopping require the use of rivets and a roofing type silicone sealant.
Cut the gutter ends at 45° as shown. Fix external and internal corner over mitred cuts, use rivets or screws and silicone.
Cut gutter ends at 45° as shown. Assemble in a similar manner to external corners.
Reduce the top rib for 25mm to allow for a slip joint. Slide the reduced end into the other end, applying a suitable sealant, then blind rivet together.
Additional information available at: